Form-A-Flo 600 Wetting Agent
Make your holograms look clearer and better with this wetting solution. Reduces streaks and promotes more uniform and quicker drying.
Item #FORMA600
$8Make Better Looking Holograms
- Helps make holograms cleaner and clearer
- Promotes uniform and quicker drying
- Reduces streaks
Form-A-Flo makes your holograms turn out cleaner and clearer. A wetting agent, this solution reduces streaks on holographic film and plates by decreasing water surface tension and by drying the hologram more quickly and uniformly.
To use Form-A-Flo, simply soak your exposed holographic film or plate into your Form-A-Flo + water solution for about 20-60 seconds right after processing your hologram with any JD Developer Kit. You only need a few to use a few drops of Form-A-Flo to see the difference.
It's an inexpensive way to get better looking holograms.
Summary: How to Use Form-A-Flo
- Dilute approximately 600 parts of distilled water to at least 1 part Form-A-Flo 600 concentrate. This is roughly 1 capful per liter.
- Process hologram with the appropriate JD Developer Kit per instructions in the kit.
- After the final rinse cycle prescribed by the JD Developer Kit, place the exposed hologram film or plate into the Form-A-Flo + water solution for about 20-60 seconds.
- Remove the hologram from the solution horizontally at a slight angle (about 20°), being mindful to avoid streaks or runs.
- Dry the hologram in a vertical position
For more detailed instructions on processing your holograms, refer to the instructions that come with the JD Developer Kit or check out our online tutorial.
